I have long had the need to measure antenna current. This can be done by a rf-current transformer and a rectifier made by a shottky diode or fast silicon diode and an integrator driving a mechanical instrument. However the dynamic range is very limited with such a setup.
Therefore I made a new rf-amperemeter design with a log detector chip from Analog Devices driven from a current transformer made out of a split core ferrite material that has response in the HF and lower VHF frequency range.The current trafo is terminated in a few ohms and the RF current conductor (actually the primary) sees only a fraction of an ohm so very little influence is done on the circuit you are measuring. (Apart from capacitive coupling and a slight leakage inductance from the current transformer windings/ferrite combination). The ferrite core is a split type and is epoxied to a clip.
I calibrated the instrument by terminating the generator in a fancooled 100W dummy load and measured the voltage over the load by an oscilloscope. Since it has a log output the dynamic range from milliamp range up to 1,4A RF current. That would peg a mechanical instrument if you would at the same time want to be able to detect a significantly lower RF-current without having to change scales with switches / pot meters etc.
Next I plan on making a OLED display on this design with an arduino controller. Its a sparetime project so lets see how long tiem it takes before I implement that.
