OKDXF published the W1FB design notebook on their website https://www.okdxf.eu/files/W1FB%20Design%20Notebook.pdf This notebook contains a lot of interesting circuits for amateur radio experimenters. Check it out.
W1FB-Design-Notebook-1No comments
OKDXF published the W1FB design notebook on their website https://www.okdxf.eu/files/W1FB%20Design%20Notebook.pdf This notebook contains a lot of interesting circuits for amateur radio experimenters. Check it out.
W1FB-Design-Notebook-1If you need to interface a 3.3V logic unit to a 5V logic CPU board you may be tempted to use the traditional two resistor voltage divider. This will work, however there is an alternative solution that uses one 1N4148 (or similar) diode. When the 5V output (right side) is high, the diode blocks but the 3.3V input is still pulled up by an internal pull up. When the 5V output (right side) is low, the diode conducts and pulls down the input on the left side: 3V input –>|– 5v “output”
The illustration is snipped from stackexchange.com
Here is a good and basic single supply OPAMP circuit cookbook from Texas Instruments.
Download the PDF HERE :Single-supply-op-amp-circuits